Skip to main content

What is the System Control Box installation order of DVLED Displays?

The System Control Box installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the System Control Box installation order: Seven system control box attachment points screwed down Control box Power cables: - Running from the back of the control box? - Running from ...

What is the LED Module installation order of the DVLED Displays?

The LED Module installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the LED module installation order: Anti-static gloves worn Began handling with delicacy, following numbers marked on the box of each module Confirmed arrow facing upwards when installing the LE...

How many sets of Ethernet and Power cables need to be attached to DVLED Cabinets?

Answer: The number of Ethernet and Power cable sets that need to be attached from the System Control Box to DVLED Display Cabinets will vary depending on Cabinet quantity. Please refer to this link to find the Cabinet quantity for the appropriate model. 

How do I know which way is correct when mounting LED modules on a DVLED Display?

Answer: The correct orientation when installing the LED module is with the arrow (towards the center of the module's PCB side) facing up. 

I need detailed product dimensions, where can I find Mechanical drawings of DVLED products?

Mechanical drawings will vary by model. The mechanical drawings can be found for the appropriate User Guide.  Solution   LD108-121: LD135-151: LD163-181: LD216-251:

Do I have to wear the anti-static gloves when installing LED modules for the DVLED Display?

Answer: Yes. Anti-static gloves prevent electrical discharge from the hands, preventing potential shorting of the LED module.

When should dehumidification be done for my DVLED?

Dehumidification should be done when the dvLED display is: being installed for the first time, in a rainy season, a snowy season, and/or in a coastal area, un-used for a long time (3+ months)

Is there another way to run the Power Cable for DVLED Displays?

Answer: The power cable can be ran through the back or bottom hole of the system control box, in order to connect power. Please click this link to see full location details.

Where is the back hole location for where the system control power cable can pass through on DVLED Displays?

Refer to the schematic below for dimensions and approximate location of the power cable back hole. Note: HDMI/USB back hole configurations are displayed here, however, your current firmware may not support the HDMI back hole configuration.

What are things to be aware of when routing Ethernet cable through back hole on my DVLED Display?

Answer:  The USB to RJ45 adapter needs to be independently purchased in order to connect the USB port to the motherboard. Cables should not be affixed too tight or have too much tension to avoid damage to USB cable and/or USB port

LED-дисплей Direct View Підтримка

General Questions

Зв'яжіться з нами

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.