Skip to main content

What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

How to check graphics card drivers in Windows?

1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.

How to setup and configure dual monitors?

Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...

Why does my TD2220 randomly receive touch signal and respond accordingly while exposed to sunlight?

TD2220 is an optical touch monitor which uses two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the sensor...

How to enable AMD FreeSync?

LED monitors produced after 2020 have FreeSync enabled by default. For LED monitors manufactured before 2020, please refer to the following instructions to enable FreeSync. To use AMD Freesync, there're some requirement with graphics cards, graphics drivers and certified monitors. 1. A compatible GPU with a DisplayPort connection. ...

How to Enable 180Hz Refresh Rate on my ViewSonic monitor?

To enable 180Hz refresh rate on your monitor, you need to turn on Overclocking in the monitor's On-Screen Display (OSD) Menu. After turning on Overclocking, you then can set the refresh rate to 180 Hz under your computer's “Display” settings. For example, in Windows go to Settings > System > Display >  Advanced display to set the refr...

How can I select 165Hz on XG2703-GS?

You can navigate to manual Image adjust on OSD menu.   Select Overclocking -> 165Hz.    

Can I Calibrate my sRGB or AdobeRGB monitor’s Luminance value below 80cd/m^2?

Can I Calibrate my sRGB or AdobeRGB monitor’s Luminance value below 80cd/m^2?   NO

What is the Native luminance of sRGB and AdobeRGB on colorbration+ ?

What is the Native luminance of sRGB and AdobeRGB on colorbration+ ?   Native Luminance of sRGB is 120cd/m^2 Native Luminance of AdobeRGB is 160cd/m^2

VG2440V Linux OS support list.

VG2440V supports all versions of Linux OS.

LED Monitor Підтримка

General Questions ColorPro™ (VP series)

Зв'яжіться з нами

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.