LED MonitorSuport - ViewSonic Romania

How to output video at 120 Hz from PS5 or Xbox Series X/S to ViewSonic monitors.

PlayStation 5 and Xbox Series X/S consoles support video output up to 120 Hz. Follow the instructions below to configure 120 Hz output. <PlayStation 5> 1. Open "Settings". 2. Select "Screen and Video". 3. Select "Enable 120 Hz Output" under "Video Output". 4. Select "Automatic" in the pop-up menu. 5. Return...

How to set power lock and menu lock?

On some monitors, there is a power button lock that locks the power and power button in the ON position. There is also a menu lock feature which can lock and unlock the OSD (On-Screen Display) Menu. Power Lock: To lock the Power Button press and hold both the [1] button and the down arrow button for 10 seconds. OSD Lock: ...

Why is there touch response randomly on my TD2220/TD2421 even nobody touches the screen?

These models are optical touch monitors which use two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the se...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

Can I turn on 1ms MPRT and FreeSync at the same time?

MPRT and FreeSync are incompatible with each other because: MPRT will KEEP the refresh rate at a high and constant point. FreeSync will CHANGE the refresh rate continuously in a range between the minimum and maximum rate of the monitor. Therefore, all ViewSonic monitors that have MPRT(1ms) and FreeSync are not able to have both functio...

Can I Calibrate my sRGB or AdobeRGB monitor’s Luminance value below 80cd/m^2?

Can I Calibrate my sRGB or AdobeRGB monitor’s Luminance value below 80cd/m^2? NO

Should I install MacOS drivers for my monitor?

MacOS does not require monitor drivers when using a ViewSonic monitor. The MacOS will automatically read the EDID information stored in the monitor and use the system information/profiler utility to detect the monitor’s specifications and capabilities. If you can not get native resolution or refresh rate on the monitor: Please check if ...

How to install the base on VX2476/VX2776/VX3276 series monitors?

You can refer to this video. 1. Lay the monitor unit face down on a flat surface, using the soft bag received or a soft material to avoid damaging the screen. 2. Insert and align the Neck of the stand (Do NOT attach the base to the neck) into the stand slot on the display. 3. Firmly push the neck into the slot while securing t...

How to set a Monitor Webcam as the Primary Camera on macOS?

1. Connect the USB cable to the monitors USB Type B port on the back of the monitor and attach the other end of the cable to an available USB port on the computer. Allow 10-15 seconds for the computer to recognize the external webcam. Please do remember to connect the video signal cable between monitor and computer. NOTE: This method will ...