LED MonitorWsparcie - ViewSonic Poland

What Kind of Stylus conductive pen is compatible with ViewSonic Touch Monitors?

It is suggested to use greater than 6mm diameter pen tip. Stylus/ Passive pen with conductive cloth material will work with all ViewSonic’s Projected Capacitive touch monitors (TD1630/TD2230/TD2430, TD2455/TD1655, TD2760). Pen tip with 8mm diameter is better for TD2230. Note: TD2455 and TD1655 stylus/passive pen (Included in ...

Why my ViewSplit template is not being centered properly?

If you run into the templates not being centered properly, please follow the below steps: 1. Right click on the desktop icon of ViewSplit and Select “Properties”. 2.When the properties window pops up select the tab “Compatibility”. 3. Select “Change high DPI settings”. 4.Check the “Program DPI” box and the drop down “I op...

What is "Low Input Lag" and which one should I choose?

Input lag means the time difference between when user controls PC and sees the response on monitor. There is a trade-off to picture/video performance. If no particular demand, it is suggested to set it to off.

How to setup and configure dual monitors?

Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...

What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

How to solve the problem with my monitor turning off automatically?

Automatic shutdowns are often caused by power-saving settings, inconsistent power supply, or signal loss. Please check the OSD timer settings first. Troubleshooting Steps: Check OSD Menu Settings (Most Common): Navigate to the [Setup Menu]. Locate [Auto Power Off] or [Sleep Timer] and ensure they are set to [Off]. Also, verify ...

How to set maximum resolution for my monitor?

Please refer to this FAQ section 1 and set to recommended display resolution.

Why is my monitor emitting a high-pitched noise or buzzing sound?

Slight electronic humming is often normal (Coil Whine); however, persistent or loud noise may require environmental troubleshooting or technical support. Check Power Source: Plug the monitor directly into a wall outlet instead of a power strip to rule out electrical interference from other devices. Adjust Brightness: Try changing the b...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion. 1.Adjust setting on the PC/laptop: (1)Set native resolution of monitor in your PC/laptop's Display settings. (2)Change Scaling in Display settings. Use the graphic card software to change ...