LED MonitorTámogatás - ViewSonic Hungary

What Kind of Stylus conductive pen is compatible with ViewSonic Touch Monitors?

It is suggested to use greater than 6mm diameter pen tip. Stylus/ Passive pen with conductive cloth material will work with all ViewSonic’s Projected Capacitive touch monitors (TD1630/TD2230/TD2430, TD2455/TD1655, TD2760). Pen tip with 8mm diameter is better for TD2230. Note: TD2455 and TD1655 stylus/passive pen (Included in ...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Can I turn on 1ms MPRT and FreeSync at the same time?

MPRT and FreeSync are incompatible with each other because: MPRT will KEEP the refresh rate at a high and constant point. FreeSync will CHANGE the refresh rate continuously in a range between the minimum and maximum rate of the monitor. Therefore, all ViewSonic monitors that have MPRT(1ms) and FreeSync are not able to have both functio...

Why does brightness go down on VP2785-4K while calibrating?

Why does brightness go down on VP2785-4K after calibration? Because on VP2785-4K, Energy saving is set to ON by default for power saving. Please turn off the Energy saving to OFF and proceed with calibration.

Why can’t I run ViewSplit when connected to ViewSonic monitor?

Your ViewSonic monitor must be set to the Main display. To verify this please follow the steps below: 1. Right click on your desktop and select “Display Settings”. 2. Click on the display number at the top that you want to make the main display and check the “Make this my main display box” under Multiple displays. 3. If th...

How to Install Unsigned Drivers in Windows 10

When installing unsigned drivers on Windows 10, Windows pops up a warning saying Windows can’t verify the publisher of this driver software. The following are instructions on how to install unsigned drivers in Windows 10. NOTE: Checking driver signatures is a security feature in Windows, and disabling it is not rec...

How to set a Monitor Webcam as the Primary Camera on macOS?

1. Connect the USB cable to the monitors USB Type B port on the back of the monitor and attach the other end of the cable to an available USB port on the computer. Allow 10-15 seconds for the computer to recognize the external webcam. Please do remember to connect the video signal cable between monitor and computer. NOTE: This method will ...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

How to fix ghosting, shadowing, or double images on the screen?

Image artifacts are typically caused by signal degradation or interference. Bypass any docking stations and use high-quality certified cables. Bypass Adapters/Docks: Remove any [Docking Stations] or [Video Splitters]. Connect the monitor directly to your PC to test the image quality. Upgrade Cable Quality: For long-distance connections...