The System Control Box installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the System Control Box installation order: Seven system control box attachment points screwed down Control box Power cables: - Running from the back of the control box? - Running from ...
The LED Module installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the LED module installation order: Anti-static gloves worn Began handling with delicacy, following numbers marked on the box of each module Confirmed arrow facing upwards when installing the LE...
Answer: The number of Ethernet and Power cable sets that need to be attached from the System Control Box to DVLED Display Cabinets will vary depending on Cabinet quantity. Please refer to this link to find the Cabinet quantity for the appropriate model.
Answer: Before attaching the System Control Box Cover, connect the control box’s power cable to the control box cover's Power Button, and then install the cover with screws to complete the installation of the System Control Box.
Answer: There may be damage to the LED module's circuitry. Please check for unlit LEDs and refer to the LED Acceptance Criteria to replace appropriately. Related link: "Do I have to wear the anti-static gloves when installing LED modules for the DVLED Display?"
Mechanical drawings will vary by model. The mechanical drawings can be found for the appropriate User Guide. Solution LD108-121: LD135-151: LD163-181: LD216-251:
Answer: Yes. Anti-static gloves prevent electrical discharge from the hands, preventing potential shorting of the LED module.
Refer to the schematic below for dimensions and approximate location of the power cable back hole. Note: HDMI/USB back hole configurations are displayed here, however, your current firmware may not support the HDMI back hole configuration.
Answer: The USB to RJ45 adapter needs to be independently purchased in order to connect the USB port to the motherboard. Cables should not be affixed too tight or have too much tension to avoid damage to USB cable and/or USB port
Solution Step 1: Insect the flight case and compare to pre-shipment photos; document any damage to the flight case on the BOL (bill of lading). Step 2: Open the flight case and compare to pre-shipment photos; document any damage to the flight case on the BOL. If you have multiple Flight Cases per dvLED product, you may refer to "Why...