The Dehumidification service (or Dehumidification process) can be used to protect the LED module(s) by displaying a dark screen and gradually transitioning to a lighter screen. The concept is to gradually remove humidity by slowly heating up the circuitry - since a lighter colored screen uses more power than a darker colored screen. The total p...
To ensure a seamless installation, a comprehensive assessment of the mounting location, structural integrity, power supply, and site logistics is mandatory. Steps and Checklist: Installation Environment Define the exact mounting location and ensure there is ample room for equipment (e.g., tools, ladders, scaffolding). Power and C...
Proper tools are essential for precise alignment and preventing electronic damage. The list includes measurement instruments, power tools, and mandatory ESD protection. Steps: Prepare tools according to the following categories: Measurement & Alignment Self-leveling laser level. Stud sensor/finder (multi-depth/material). 4-vial...
Answer: Please refer to the LED dead pixel specification in the User Manual to determine if it needs replacing, or contact the local service provider for proper assessment. Click each model to view detailed replacement specificationsDeactivated pixels determination for LED module replacement based on Acceptance Criteria for 1) whole dis...
Yes. Please make sure you follow the below steps. Turn off Wireless hotspot on LDM/LDC. (Settings --> Network --> Wireless hotspot --> Disable) Use Mouse to select the display in vCast under Display group settings --> Device list
Solution The signal will be sent from the “Main Board” and transmitted in three ways: 1) The first path is from the “Audio Board” to the “Speaker” 2) The second path is to the “RS232 Module” 3) The third path is from the “Transfer Board” to the “Receiving Board,” and from the “Receiving Board” to the “LED Module.” ...
Answer: No. There is no trolley option offered at this time. The current available trolley options are for the 108", 135", 163" DVLED sizes.
Answer: "Hard calibration" is a form of hardware calibration that fine tunes the color and brightness for specific LED modules on the DVLED Display. Situations in which hard calibration may be required: LED Module position is changed or LED Module is replaced with a spare, LED Modules from a different color batch need to be used, LED M...
Answer: Chip-on-Board or "COB" refers to the mounting of a bare LED chip in direct contact with a substrate, to produce LED arrays. Differences between SMD LED and COB LED consists of: SMD COB Horizontal Chip Flip Chip has LED PCB does NOT have LED PCB (smaller chip) has gold wires does NOT have gold wires (less blockage of light)...