<Notice> The firmware of M1+ will not be used on M1+_G2/_V or M1+ -2. 1. Go to “Downloads” -> ”Driver & Software” by searching M1+ from ViewSonic website to download “M1+ Firmware Update v2.03”. 2. Unzip the downloaded files and copy the Firmware files, “MstarUpgrade.bin" and "M1+WW.bin” to a FAT32 formatted USB drive. 3. Po...
Some users may experience only a black screen being projected when trying to wirelessly cast from an iPhone with iOS 16.2 on a smart projector. If this happens, please turn on and connect the projector to the Internet and wait for the projector to automatically connect to the ViewSonic server and update. Note: Please wait at least 30 minu...
Install the wall mount using the template, mount the projector for alignment, and set up the Laser Curtain module for interactive touch capabilities. Step-by-Step Instructions: Wall Layout: Use the included [Installation Template] to mark the drilling holes on the wall. Ensure the center line matches your projection surface's center. ...
Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card 2. Make sure your devi...
1. Ensure that your monitor has built-in speakers. You can check it on Product's website page -> Specification -> Audio. 2. Check the cable connection: a. Make sure the connection is secured. b. Re-plug or try another HDMI (Premium) certificated cable in direct connection. c. If using a VGA cable, ensure the audio cable is connected ...
Most fan noise issues are related to settings or ventilation. Check the High Altitude Mode and ensure the vents are clear before considering repair. Troubleshooting Steps: Verify Device Specs: If you own a fanless portable model and hear strange noises, contact support immediately as there are no moving parts intended to make sound....
Automatic shutdown is usually triggered by overheating protection, power-saving settings, or lamp compatibility issues. Check the LED indicator lights for diagnostic clues. Troubleshooting Steps: Check LED Indicators: Temp Light (Red): Indicates overheating. Ensure vents are clear and fans are running. Let the unit cool for 30 minute...
This is normal operation. It is either a temporary cooling phase (3–5 mins) or a result of the Network Standby feature being enabled. Detailed Explanation: 1. Cooling Down Period Behavior: The fan remains on for 90 seconds to 5 minutes after pressing the power off button. Purpose: To dissipate residual heat from the lamp. Do not unplug ...
Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...
Auto-shutdown is typically triggered by overheating protection. Ensure proper ventilation, clean the dust filters, and enable "High Altitude Mode" if necessary. Check LED Indicators: If the Temp light is red or flashing after shutdown, the projector has overheated. Improve Airflow: Keep at least 50cm of clear space around intake an...