Automatic shutdowns are often caused by power-saving settings, inconsistent power supply, or signal loss. Please check the OSD timer settings first. Troubleshooting Steps: Check OSD Menu Settings (Most Common): Navigate to the [Setup Menu]. Locate [Auto Power Off] or [Sleep Timer] and ensure they are set to [Off]. Also, verify ...
Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...
Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...
Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...
1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.
Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...
Adjust your refresh rate via "Advanced Display Settings" for a smoother visual and gaming experience. Open Settings: Right-click on your desktop and select [Display settings]. Advanced Options: Scroll down and click on [Advanced display settings]. Select Refresh Rate: Under the "Choose a refresh rate" dropdown, select the highest ...
LED monitors produced after 2020 have FreeSync enabled by default. For LED monitors manufactured before 2020, please refer to the following instructions to enable FreeSync. To use AMD Freesync, there're some requirement with graphics cards, graphics drivers and certified monitors. 1. A compatible GPU with a DisplayPort connection. ...
This setting is to provide better picture performance if user’s screen are mostly dark scenes. If no special needs(ex: playing shooting games in dark scenes), it is suggested to turn off.
Certain preset modes (ViewMode) are factory-calibrated for specific visual tasks and will lock parameters to maintain optimal performance. Switch to [Standard] mode to regain manual control. Step-by-Step Instructions: Press the [Menu] button (located on the back or bottom of the monitor) to open the OSD menu. Navigate to the [ViewMode...