ProjectorPodpora - ViewSonic Czech Republic

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu. 2.Check the light source level and make sure it’s on Full or Normal. 3.Turn off or reduce environmental luminance where the projector is in use.

Why a black border on the top/bottom or sides of the image from the projector?

Please check below: 1.Plesae refer to the user guide and adjust Aspect ratio with example below. 2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.

How to download the latest drivers for my projector

Option 1: Download from the ViewSonic Website Go to http://www.viewsonic.com/us/downloads_section/ Enter the Product Name, Product series and model number. Select the driver based on the operating system of your computer. Once the file downloads, double-click to open and start the installation. If you select Save, double-click on the downl...

Why the image is pixelated from my projector?

Usually this is related to unmatched output resolution setting and content. For example, setting 720P resolution output to a 4K projector or playing a 720P video on a 4K projector in full screen would cause pixelated. Please make sure to set recommended resolution by referring to this FAQ.

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below. a. 3D ready projector b. 3D Blu-Ray player c. 3D content d. Active 3D glasses 144Hz e. HDMI Premium Certificate cable 2. Here is the playback process below. a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable. b. T...

How do I connect external speaker(s) to my projector?

1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...

How to change the projector lamp in a projector?

The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page. <Note> It is recommended that you use an authentic ViewSonic replacement lamp.

Why Can't I Power Off the Projector via its Remote Control?

For Models: PA/PG/PX Series “Power On” and “Power Off” are separated as two (2) different buttons on the remote control. This is different from the PJD series.

There are issues connecting an external monitor to a computer/projector

If the external monitor/ projector is not automatically detected and displaying an image, you will need to use a function key to enable or activate the function. Laptop manufacturers have different methods to activate an external monitor. Refer to the laptop's user guide/manual or the manufacturer for instructions to activate the video port for...

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...