1. Download the attached license file. 2. Select the correct Time Zone. 3. Please follow the below procedures to install the Signage Manager license: license URL:https://support.viewsonic.com/helpdesk/attachments/33040907670
Please press the "MENU" button on the remote controller to enter the setting page and then set "vSigange" to “OFF”. .
Upgrade under the factory menu Copy MstarUpgrade.bin in USB and Insert U disk to the USB port Press Input menu and then press 2 5 8 0 to activate factory menu (Fig. 1) Move to “Upgrade Main” item and press OK button to confirm. (Fig. 2) Select “Confirm” to confirm the upgrade (Fig. 3), the system will automatically reboot and start the up...
If you are unable to sync the contents, there may be a connection issue. To verify if the admin is sync with the player, there is a JSON API in vSignage. 1. First make sure your windows firewall setting has allow vSigange to access. 2. Please use this API to check if source player see any other players and campaign. Open the Chrome br...
1. Is it correct of RS232 daisy chain cable ? 2. In OSD menu, General settings -> Eco mode please set to Normal. (If set to Low power standby, the unit can power OFF but can’t power ON) 3. The RS232 daisy chain cable is 2.4mm – 2.4mm
Download ADB from https://developer.android.com/studio/command-line/adb.html 1. Run cmd commend and go to the adb save folder that connect to device via Adb over TCP, if use Adb wire, skip this step adb connect {ip} for example: adb connect 192.168.2.112 2. Take screenshot and save to device adb shell screencap -p /sdcard/...
While editing content with Signage Manager, it will compress and save photo in lower quality. Please follow below procedures to replace the photo. 1. After finishing editing in Signage Manager, choosing “Export to USB”. 2. Open “File Explorer” and locate USB drive in SMIL/media folder. 3. Copy original photos to this folder and...
There are two methods to get back to the dashboard. 1. Press up button on the remote control to go to the dashboard 2. Connected to a mouse, directly press and hold anyone of the corner area, after successfully triggering the countdown, the corner area will flash in reverse (as shown in the figure). It will exit after ten seconds.
Yes. The capability for Enterprise authentication depends on the hardware specifications of the installed Wi-Fi module/dongle and its firmware compatibility. Instructions & Steps: Hardware Verification: Supported Wi-Fi security protocols are dictated by the Wi-Fi Module/Dongle. Please ensure your module supports 802.1X / WPA2-Enterprise ...
ViewSonic CDE30 Series power save modes: Which mode should i use? There are four Power Save modes to choose from and knowing which one to use depends on the application. For this scenario we will cover digital signage, information and monitoring systems and meeting rooms where always-on, wake up on active signal and fast boot time is a must...