Please see the table below: Supported Size (Max. Size) NTFS Format FAT32 Format Read Write Read Write USB Memory Stick 256 GB V N/A V V USB HDD 2 TB V N/A V V Micro SD 256 GB V N/A V V Note: 1. Windows 10 built-in format tool only supports FAT32 format up to 32 GB. 2. Firmware upgrade only supports FAT32 format.
In order to enable the PgUp and PgDn function on your remote controller for the PX701-4K projector, please follow the instruction below: Besides your video cable (HDMI), please connect an additional USB cable from the back of the PX701-4K projector to your PC/Laptop. Change the control method to USB by entering your OSD menu -> System ...
Image artifacts are often caused by poor cable quality or signal interference. Use high-quality cables and avoid using excessive adapters. Use Bundled Cables: Test using the [original video cable] provided with the product. Remove Intermediate Devices: Disconnect any [docking stations], [adapters], or [video splitters]. Connect the ...
Slight humming is often normal for 4K models due to XPR technology. For other noises, check fan settings and power stability. Identify Normal XPR Noise (4K Models): 4K UHD projectors use XPR pixel-shifting technology, which produces a subtle high-pitched hum during operation. This is normal and not a defect. Adjust Fan Settings: Go to ...
Use a USB-C cable or an appropriate HDMI adapter for a stable, low-latency wired connection. USB-C Direct Connection (Recommended): Use a USB-C cable that supports video transmission (using the cable provided with the projector is highly recommended). Connect your device directly to the projector's [USB-C] port. Select [USB-C] a...
Check all cable connections, verify the LED indicator on the AC adapter, and test a different wall outlet. Verify Connections: Ensure the power cord is firmly seated in the AC adapter "brick" and the plug is fully inserted into the wall outlet. Check Adapter LED: Look for a small light on the adapter unit. LED On: The adapter is re...
Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...
Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...
Auto-shutdown is typically triggered by overheating protection. Ensure proper ventilation, clean the dust filters, and enable "High Altitude Mode" if necessary. Check LED Indicators: If the Temp light is red or flashing after shutdown, the projector has overheated. Improve Airflow: Keep at least 50cm of clear space around intake an...
Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...