Direct View LED DisplaySupport

What is the Cabinet installation order of the DVLED Floor Stand configuration?

The Cabinet installation order varies from the Wall-mount configuration. Please follow the steps in the respective order for the Floor Stand configuration: Cabinet B moved to the left side of the floor stand bracket Ensured rear-cabinet mounting bracket is securely placed onto the top cross beam of the floor stand Ensured notches under the ...

What is the Cabinet installation order of the DVLED Wall-mount configuration?

The Cabinet installation order varies from the Floor Stand configuration. Please follow the steps in the respective order for the Wall-mount configuration: Cabinet C moved to the center of the installation position, and Cabinet B placed to the left side of Cabinet C Hex wrench used to help align and ensure no tile-to-tile steps before engagi...

What is the LED Module installation order of the DVLED Displays?

The LED Module installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the LED module installation order: Anti-static gloves worn Began handling with delicacy, following numbers marked on the box of each module Confirmed arrow facing upwards when installing the LE...

How do I remove LED Modules from the DVLED Display?

Solution Step 1: Wear anti-static gloves before handling the LED Modules. Step 2: Remove the Vacuum Suction Tool from the box and press its power switch to use it. Please charge it with the included power supply and make sure the vacuum suction tool is kept in a fully charged state. Step 3: Move the Vacuum Suction Tool to t...

Why is an entire column of LED Modules not on even though my DVLED Display is powered on?

DVLED Display with an entire column of unlit LED Modules. Answer: There may be poor connection or loose wiring with the connectors from the System Control Box to the LED Module adapter board. Solution The column's most bottom LED Module will need to be removed with the Vacuum Suction Tool in order to access the connectors. ...

How do I adjust the LED Module edge brightness on my DVLED Display?

When you find that the edge brightness of the LED module is different from that of the adjacent modules, the following procedure below can be followed in order to resolve the problem. Solution Step 1: Use the USB B-to-A cable and HDMI cable to connect the monitor to the computer, and switch the monitor's input source to HDMI. Step...

What is the Bracket installation order of the DVLED Floor Stand configuration?

The Bracket installation order varies from the Wall-mount configuration. Please follow the steps in the respective order for the Floor Stand configuration: Bottom cross beam installed to the left and right supports. Top cross beam installed to the left and right supports. Original mounting bracket removed from the top and reattached to the ...

Where is the back hole location for where the system control power cable can pass through on DVLED Displays?

Refer to the schematic below for dimensions and approximate location of the power cable back hole. Note: HDMI/USB back hole configurations are displayed here, however, your current firmware may not support the HDMI back hole configuration.

How many sets of Ethernet and Power cables need to be attached to DVLED Cabinets?

Answer: The number of Ethernet and Power cable sets that need to be attached from the System Control Box to DVLED Display Cabinets will vary depending on Cabinet quantity. Please refer to this link to find the Cabinet quantity for the appropriate model.

What is "Dehumidification" service for dvLED displays?

The Dehumidification service (or Dehumidification process) can be used to protect the LED module(s) by displaying a dark screen and gradually transitioning to a lighter screen. The concept is to gradually remove humidity by slowly heating up the circuitry - since a lighter colored screen uses more power than a darker colored screen. The total p...