LED MonitorSupport - ViewSonic Bangladesh

How to enable/disable VX3258-2KC-MHD crosshair toggle?

If you see a crosshair in the middle of your VX3258-2KC-MHD monitor’s screen, please perform the step below. With the monitor powered on, press the joy key downward on the back of the monitor to toggle the crosshair on or off. To bring it back up press downward on the joy key again.

What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

How to solve the problem with my monitor turning off automatically?

Automatic shutdowns are often caused by power-saving settings, inconsistent power supply, or signal loss. Please check the OSD timer settings first. Troubleshooting Steps: Check OSD Menu Settings (Most Common): Navigate to the [Setup Menu]. Locate [Auto Power Off] or [Sleep Timer] and ensure they are set to [Off]. Also, verify ...

Why is my monitor emitting a high-pitched noise or buzzing sound?

Slight electronic humming is often normal (Coil Whine); however, persistent or loud noise may require environmental troubleshooting or technical support. Check Power Source: Plug the monitor directly into a wall outlet instead of a power strip to rule out electrical interference from other devices. Adjust Brightness: Try changing the b...

What to do if there is flickering image with my monitor?

Check the monitor: Please do memory recall. Please refer to this FAQ Check device setting: Please check and set to recommended refresh rate. You can refer to this video. https://www.youtube.com/watch?v=sAkbjPiLNcE If possible, please connect monitor to another device with different input. If above doesn’t help, please contact ViewSo...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

Does ViewSonic provide Linux drivers for monitors?

No dedicated driver is required. ViewSonic monitors follow VESA standards, allowing Linux to automatically recognize the display via EDID. Plug and Play: Simply connect your monitor; the Linux kernel will automatically detect the hardware. Adjust Display Settings: Navigate to your distribution's [Settings] > [Displays] to configur...

How to set the maximum resolution on your LED monitor?

Adjust the display resolution to the "Recommended" setting in Windows to ensure optimal clarity and eliminate black borders. Adjust System Resolution: Right-click on the desktop and select [Display settings]. Under the [Display resolution] dropdown, select the value labeled [(Recommended)]. Disable Hardware Overscan: Press ...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...